DTF Pressing Instructions

Follow these simple steps to get the best results when applying your DTF (Direct-to-Film) transfers. With the right heat press settings, your prints will be vibrant, durable, and long-lasting.

✅ Recommended Heat Press Settings

  • Specify Heat Press setting: 315-325 degrees for 15 seconds. Cold peel.

📝 Step-by-Step Pressing Guide

1. Pre-Press Your Garment

  • Place the garment on the heat press.

  • Press for 3–5 seconds to remove moisture and wrinkles.

2. Position the Transfer

  • Place your DTF transfer film face-down onto the garment where you want the design applied.

  • Use heat tape if needed to keep it from shifting.

3. Press the Transfer

  • Close the heat press at 280–320°F.

  • Apply medium to firm pressure.

  • Hold for 12–15 seconds.

4. Peel the Film

  • Let the transfer cool for a few seconds.

  • Peel the film warm or cold, depending on your press and garment type (most customers prefer a warm peel).

5. Final Re-Press (Highly Recommended)

  • Cover the design with parchment paper or a Teflon sheet.

  • Re-press for 5–7 seconds to lock in durability and give a smooth finish.

⚡ Pro Tips for Best Results

  • Always test press on a sample garment before bulk production.

  • Adjust pressure if edges don’t fully adhere.

  • Avoid ironing directly on the transfer.

  • Wash inside-out in cold water and tumble dry low for maximum longevity.

❌ Common Mistakes to Avoid

  • Not pre-pressing (can cause moisture bubbles).

  • Using too low of a temperature (results in incomplete adhesion).

  • Uneven pressure (may cause peeling on edges).